IP Office Installation: IP400 Basic Installation
|
IP Office Installation: IP400 Basic Installation
|
|
Adding a WAN3 Module |
|
WAN3 expansion modules connect to the IP Office control unit using a LAN cable. It is preferred that the cable is connected directly to the IP Office control unit rather than via any other equipment. A green 1 meter (3'3'') LAN interconnect cable is supplied with the module for this purpose though a replacement cross-over cable is required if connecting to an IP412 control unit. The WAN3 module requires its own IP address on the same subnet as the IP Office control unit. A WAN3 module obtains that address using DHCP so a DHCP server is required for installation. |
This module is supplied with a LAN interconnect cable and a power supply unit. An appropriate locale specific power cord for the power supply unit, and cables for the WAN ports on the rear of the module must be ordered separately.
Installation Requirements
| • | o Installation space either on or under the existing IP Office control unit. |
| • | o Switched power outlet socket. |
| • | o System password. |
| • | o Free LAN port on the front of the control unit. |
| • | o Grounding Requirements |
| • | o Functional Ground - Connection of a functional ground is recommend for all modules. |
Tools Required
| • | o Manager PC. |
| • | o DHCP server (preferably the IP Office itself). |
| • | o Tools for rack mounting (optional). |
Parts and Equipment Required
| • | o WAN3 10/100 Module Each module is supplied with a suitable external power supply unit and a RJ45-RJ45 LAN interconnect cable. |
| • | o For the IP412 control unit an RJ45-RJ45 LAN crossover cable is required. |
| • | o WAN Cables A V.24, V.35 or X.21 WAN cable is required for connection to each WAN port. The cable used determines the signalling provided by that port. |
| • | o Cable labeling tags. |
Procedure: Adding a WAN3 Module
| 1. | Switch off power to the IP Office control unit. |
| 2. | Connect the WAN3 module to the control unit using the LAN cable.  |
| 3. | Switch on power to the WAN3 10/100 module. |
| 4. | Switch on power to the IP Office Control Unit. |
| 5. | Using Manager receive the configuration from the IP Office system. |
| 6. | Select  Control Unit. If the WAN3 10/100 module is not listed, right-click and select New. A Select WAN unit window appears which will allows the network to be scanned for the WAN3 unit. |
| 7. | When the unit is located, select it and then OK. |
| 8. | Send the configuration back to the IP Office system. |
|
© 2009 AVAYA 15-601042 Issue 20.i.- 10:12, 18 November 2009 (adding_a_wan3.htm) Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others. All trademarks identified by (R) or TM are registered trademarks or trademarks respectively of Avaya Inc. All other trademarks are the property of their respective owners. Last Modified: 02/01/2009 |
