BRI Port (To)

$Show\Hide Navigation$ IP Office Installation: System Components > Physical Ports

BRI Port (To)

These ports are BRI To interface ports for connection to external BRI trunk services. Note that BRI ports found on the IP400 So8 module are BRI-S interface ports for connect to ISDN terminal devices, see BRI Port (So).

PRI/BRI Trunk Cable

This cable is used to connect from IP Office BRI/PRI trunk ports to the line providers network termination equipment. If that equipment does not use RJ45 sockets, the cable may need to be stripped and rewired or an alternate cable used. The appropriate signal pin-outs and wire colours are detailed below.

pri_cable

IP Office				Wire	Network Termination
BRI	RJ45	BRI	PRI	Wire	PIN	RJ45
	1	–	Rx-A	White/Orange	1
	2	–	Rx-B	Orange/White	2
	3	Tx-A	–	White/Green	3
	4	Rx-A	Tx-A	Blue/White	4
	5	Rx-B	Tx-B	White/Blue	5
	6	Tx-B	–	Green/White	6
	7	–	–	White/Brown	7
	8	–	–	Brown/White	8

•	Supply: BRI/PRI trunks cards are not supplied with these cables.

•	Cable Color: Red.

•	SAP Code: 700213440.

•	Standard Length: 3m/9'10".

•	Maximum Length: 5m/16'5''.

•	Though not used pins 7 and 8 are through connected for ease of construction.

© 2009 AVAYA
15-601042 Issue 20.i.-
10:13, 18 November 2009
(bri_rj45_.htm)

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others. All trademarks identified by (R) or TM are registered trademarks or trademarks respectively of Avaya Inc. All other trademarks are the property of their respective owners.

Last Modified: 02/01/2009