V.24 WAN Cable

$Show\Hide Navigation$ IP Office Installation: System Components > Physical Ports

V.24 WAN Cable

This cable is used for connection an IP Office 37-way D-type WAN port to the V.24 WAN service providers equipment.

v24_cable

IP Office WAN Port

Signal

V.24 WAN Service

Ground

DTR: Data Terminal Ready.

Rx: Receive Data

Tx: Transmit Clock

DCD: Data Carrier Detect.

CTS: Clear To Send.

Tx: Transmit Data.

RTS: Request To Send.

Rx-Clk: Receive Clock.

RI: Ring Indicator.

DSR: Data Set Ready.

•	At the IP Office end pin 25 is connected to pin 6.

•	At the IP Office end pin 19 is connected to the Screened Cable Drain Wire.

•	Supply: This cable is not supplied with the control unit or WAN3 module. It must be ordered separately.

•	SAP Code: 700213416

•

Cable: 12-core screened cable. Each core is 7/0.203mm (24 AWG) tinned copper stranded wire, nominal capacitance of 95pF/m, resistance of 92 ohms/km, screened with tinned copper braid, maximum working voltage of 440V rms and a maximum current per core of 1A rms. The maximum core to core capacitance must not exceed 800pF.

•	Maximum Length: 5m/16'5''. This is the maximum length that should be used if the above cable is replaced with an alternate cable.

© 2009 AVAYA
15-601042 Issue 20.i.-
10:13, 18 November 2009
(v24wancable.htm)

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others. All trademarks identified by (R) or TM are registered trademarks or trademarks respectively of Avaya Inc. All other trademarks are the property of their respective owners.

Last Modified: 19/05/2008