Show\Hide Navigation IP Office Installation:
Back Forwards Print Synch Bookmark and Share Bookmark and Share

Shelf/Wall Mounting (SOE)

Small Office Edition control units can be shelf or wall mounted. Four screw head retaining slots are moulded into the base of the unit for this purpose. In addition a plastic Z-shaped bracket and screw is supplied with the unit for securing it in position.

icon information Installation Requirements

Horizontally on a shelf - leaving sufficient space for the cabling at both front and rear of the unit.
Vertically from a wall – with the front panel facing down only.

soe_mounting

The Z-shaped bracket must not be used as the sole mounting fixture.

icon tools Tools Required

1.o Drill and drill bits suitable for the wall fixings selected.
2.o Screwdrivers.

icon parts Parts and Equipment Required

1.o Wall fixings suitable for 3 No.8 screws.
2.o 3 x No.8 panhead screws, minimum 25mm long.

 

icon process Procedure

1.Using a drill size suitable for the selected wall fixing, drill two holes 6.3 inches (160mm) apart either horizontally or vertically.
2.Insert the wall fixings.
3.Insert the two No.8 panhead screws leaving approximately 0.4 inches (10mm) proud of wall.
4.Fit the Z-shaped bracket (2) onto the base of the unit using the M3 self tapping screw supplied.

soe_brackets

5.Slide the unit onto the two screws, locating them into two of the retaining slots (1).
6.Mark the position of the retaining screw for the Z-bracket.
7.Remove the unit from the wall and drill a hole and insert a wall fixing for the Z-bracket position.
8.Re-position the unit and secure with a No. 8 panhead through the slot of the Z-shaped bracket.

 

 

© 2009 AVAYA
15-601042 Issue 20.i.-
10:13, 18 November 2009
(wallmounting.htm)

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others. All trademarks identified by (R) or TM are registered trademarks or trademarks respectively of Avaya Inc. All other trademarks are the property of their respective owners.

Last Modified: 14/11/2007