WAN Port Settings
Show\Hide Navigation Manager: Configuration Settings
Up Down Back Forwards Print Synch Bookmark and Share Bookmark and Share

WAN Port Settings

icon large wan

These entries are used to configure the operation of IP Office WAN ports. These are the 37-way D-type WAN ports found on the rear of all IP Office control units except the Small Office Edition.

Additional WAN ports can be added by the installation of up to two WAN3 expansion modules, each module providing 3 additional WAN ports. On the Small Office Edition control unit, a single WAN port can be added by the installation of a WAN trunk card at the rear of the unit. For full details of installing additional WAN ports, refer to the IP Office Installation Manual.

Physical WAN are not supported on the IP500.

 

Creating a Virtual WAN Port
WAN services can be run over a T1 PRI trunk connection. This requires creation of a virtual WAN port. For full details refer to Using a Dedicated T1/PRI ISP Link in Appendix A.

1.Select icon large wan WAN Port.
2.Click icon new entry and select PPP.
3.In the Name field, enter either LINEx.y where:
·LINE must be in uppercase.
·x is the line number. For a PRI/T1 module in Slot A, this will be 1. For a PRI/T1 module in Slot B, this will be 5.
·y is the lowest numbered channel number to be used by the WAN link minus 1. For example, if the lowest channel to be used is channel 1 then y = 1 - 1 = 0.
4.In the Speed field, enter the total combined speed of the maximum number of channels sets in the Service. In this example, 12 channels x 64000 bits = 76800.
·Note: The maximum number of channels that can be used will be limited by the number of data channels supported by the IP Office Control Unit and not already in use.
5.In the RAS Name field, select the RAS name created when the new Service of that name was created.
6.Click OK.

 

© 2009 AVAYA
15-601011 Issue 23.p.-
07:06, 30 October 2009
(wan_port_settings.htm)

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others. All trademarks identified by (R) or TM are registered trademarks or trademarks respectively of Avaya Inc. All other trademarks are the property of their respective owners.

Last Modified: 06/03/2008